Take a look at the layout and plan it out in your mind first.
To make the tutorial clear, we use spray-painted pillars and colored acrylic panels.
Tip: C2 is thicker than B2, and C1 is thicker than B1.
Identify the parts shown in the image.
Insert L1 into the sliding rail.
Align the top of the ruler with the pillar, install and tighten W1.
Assemble the second pillar using the same method.
Insert two M1 into each sliding rail.
Insert W1 and tighten.
Align the left end of the caliper with the pillar, use holes 2 and 3.
Align the left end of the caliper with the pillar, use holes 1 and 3.
Tighten B1 to secure the motherboard.
Assemble as shown and tighten W1.
Fix the foot pads to the base.
Install the upper part onto the base and tighten the screws.
Standard power supply installation, with the power cable port facing upwards.
Standard power supply installation, with the power cable port facing downwards.
The above image shows the installation method for an SFX power supply.
The above image shows the installation method for a 1U power supply.
The left button is for power on, and the right one is for reset.
The image shows the fixation of the power and reset buttons.
Common jumper wire connections.
Other installation methods — the position is flexible.
DIY case, hard drive mounting positions are flexible.
DIY case, hard drive mounting positions are flexible.
DIY case, hard drive mounting positions are flexible.
If the PCIE bracket blocks the video output port,
you can offset it to expose the port.
With enough force, it will fit — just hammer it in.